Allied Telesis AT-S60 - Manual (Page 765)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 765
Setting the Switch’s VLAN Mode
This section contains the procedure for setting a switch’s VLAN mode.
You can configure a switch to support port-based and tagged VLANs or
to operate in the Basic VLAN mode. A change to VLAN status is not
activated until you reset the switch.
Note
Refer to Chapter 18, Tagged and Port-based Virtual LANs on page
401, for descriptions of port-based and tagged VLANs and the Basic
VLAN mode.
To set the switch’s VLAN mode, perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Scroll down to the Configuration section of the Page.
3. In the circle next to the Switch Mode field, choose one of the
following:
❑ Click Tagged to permit the switch to support both port-based
VLANs and tagged VLANs. This is the default.
❑ Click Basic to permit the switch to operate in the Basic VLAN
mode.
4. Click Apply.
The following confirmation message is displayed:
The switch will be rebooted for the change to take
effect. This page will not be available while the
switch reboots. Continue anyway?
5. Select OK to continue with the reboot. Select Cancel to cancel the
reboot.
A change to VLAN status is not activated until you reset the
switch. To reset the switch, refer to Resetting a Switch on page
604.