Allied Telesis AT-S60 - Manual (Page 663)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 663
Configuring IGMP Snooping
To configure IGMP snooping from a web browser management session,
perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the IGMP Tab.
The Configuration IGMP Tab is shown in Figure 225.
Figure 225 Configuration System Page, IGMP Tab
3. Adjust the IGMP parameters as necessary.
The parameters are explained below:
Enable IGMP Snooping
Enables and disables IGMP snooping on the switch. A check in the
box indicates that IGMP is enabled.
Multicast Host Topology
Defines whether there is only one host node per port or multiple
host nodes per port. Possible settings are Single-Host/Port (Edge)
and Multi-Hosts/Port (Intermediate).