Allied Telesis AT-S60 - Manual (Page 138)

Chapter 8: Port Trunking
Section I: Basic Features 138
2. From the Port Menu, type 4 to select Port Trunking.
The Trunk Configuration menu is shown in Figure 37 on page 132.
3. Type 3 to modify a trunk.
The Modify Trunk menu is shown in Figure 38 on page 136.
4. Select 2 - Add ports to Trunk to add ports to an existing trunk.
The following prompt appears:
Enter Trunk ID: [1 to 22] -> 1
5. Enter the trunk ID number of the trunk you want to modify and press
Return. A list of the current trunk IDs appears in the Modify Trunk
menu. See Figure 38 on page 136.
The following prompt appears:
Enter ports to add to trunk:
6. Enter the ports you want to add to the trunk and press Return.
For information about how to specify ports, see Specifying Ports
on page 34.
For 10/100 port trunks, all the ports that comprise the trunk must
be on the same line card.
For GBIC port trunks (or ports with speeds up to 1,000 Mbps), all
the ports that make up the trunk must be on different line cards.
The Modify Trunk menu is updated with the new ports.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes to save the new ports.