Allied Telesis AT-S60 - Manual (Page 92)

Chapter 5: SNMPv1 and SNMPv2c Configuration
Section I: Basic Features 92
Modifying
SNMPv1 and
SNMPv2
Community
Attributes
For each SNMPv1 and SNMPv2c community, you can modify several
attributes. See the following procedures:
❑ Adding SNMP Manager and Trap Receiver IP Addresses on page
92
❑ Deleting Attributes from a Community on page 94
❑ Changing the Access Mode of a Community on page 95
❑ Changing the Community Status on page 97
❑ Changing the Community Open Access Mode on page 98
Adding SNMP Manager and Trap Receiver IP Addresses
To add IP addresses to the list of SNMP Manager and Trap Receivers,
perform the following procedure:
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure SNMP Menu is shown in Figure 22 on page 87.
5. To configure SNMPv1 and SNMPv2c parameters, type 3 to select
Configure SNMPv1 & SNMPv2c Community.
The Configure SNMP Community Menu is shown in Figure 23 on
page 89.
6. To modify SNMP community attributes, type 3 to select Modify SNMP
Community.