Allied Telesis AT-S60 - Manual (Page 695)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 695
Configuring the SNMPv3 Protocol
To configure the SNMPv3 protocol, you need to configure the SNMPv3
tables. To enable a manager to access the SNMPv3 protocol on the
switch, you need to enable the SNMP protocol. See the following
procedures:
❑ Enabling the SNMP Protocol on page 696
❑ Configuring the SNMPv3 User Table on page 698
❑ Configuring the SNMPv3 View Table on page 705
❑ Configuring the SNMPv3 Access Table on page 710
❑ Configuring the SNMPv3 SecurityToGroup Table on page 717
❑ Configuring the SNMPv3 Notify Table on page 722
❑ Configuring the SNMPv3 Target Address Table on page 727
❑ Configuring the SNMPv3 Target Parameters Table on page 733
❑ Configuring the SNMPv3 Community Table on page 740
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with the SNMPv1 or an SNMPv2c protocol. Allied
Telesyn does not recommend this configuration.
For reference information about the SNMPv3 protocol, see Chapter 17:
SNMPv3 Configuration on page 293.