Allied Telesis AT-S60 - Manual (Page 717)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 717
Configuring the SNMPv3 SecurityToGroup Table
You can create, delete, and modify an SNMPv3 SecurityToGroup Table
entry. See the following procedures:
❑ Creating a SecurityToGroup Table Entry on page 717
❑ Deleting a SecurityToGroup Table Entry on page 719
❑ Modifying a SecurityToGroup Table Entry on page 720
For reference information about the SNMPv3Configuring the SNMPv3
SecurityToGroup Table on page 717.
Creating a
SecurityToGroup
Table Entry
To create an entry in the SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 252.
Figure 252 SNMPv3 SecurityToGroup Table Page