Allied Telesis AT-S60 - Manual (Page 110)

Chapter 6: Port Parameters
Section I: Basic Features 110
9 - Duplex:
Use this selection to configure the duplex mode of the port.
See Table 2 for duplex settings for each line card. Choose from the
following selections:
❑ Full - Indicates full-duplex mode.
❑ Half - Indicates half-duplex mode.
A - MDI/MDIX Crossover:
Use this selection to configure the Ethernet interface for the port.
Choose from the following settings:
❑ Type MDI to indicate the MDI setting.
❑ Type MDI/X to indicate the MDI-X setting.
AT-8413 GB/T
copper port 10/100/1000 Mbps
AT-8413 GB/T
fiber port 1000 Mbps
AT-8414/ST
AT-8414/SC 10 Mbps
Table 2 Port-Duplex Settings on Line Cards
Line Card Port Duplex
AT-8411 TX Full and half
AT-8412/SC FX
AT-8412/MTFX Full only
AT-8413 GB/T
copper port Full only
AT-8413 GB/T
fiber port Full only
AT-8414/ST
AT-8414/SC Full and half
Table 1 Line Card Port-Speed Settings
Line Card Port Speed