Allied Telesis AT-S60 - Manual (Page 563)

AT-S60 Management Software User’s Guide
Section V: Security Features 563
The Configure Authenticator Port Access Parameters Menu is
shown in Figure 183.
Figure 183 Configure Authenticator Port Access Parameters Menu
6. Select the parameter that you want to modify. They are described
below:
1 - Port Control
Choose from the following values:
❑ Auto: Enables 802.1X port-based authentication and causes the
port to begin in the unauthorized state, allowing only EAPOL
frames to be sent and received through the port. The
authentication process begins when the link state of the port
changes. The switch requests the identity of the client and begins
relaying authentication messages between the client and the
authentication server. The switch identifies each client that
attempts to access the network by the client's MAC address. This
is the default value.
❑ Force-authorized: Disables 802.1X port-based authentication
and causes the port to transition to the authorized state without
any authentication exchange required. The port transmits and
receives normal traffic without 802.1X-based authentication of
the client.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Production Switch 142
User: Manager 00:14:37 25-Jan-2004
Configure Authenticator Port Access Parameters
Configuring Port 1.3
1 - Port Control ........ Auto
2 - Quiet Period ........ 60
Seconds
3 - Tx Period ........... 30 Seconds
4 - Reauth Period ....... 3600 Seconds
5 - Supplicant Timeout .. 30
Seconds
6 - Server Timeout ...... 30 Seconds
7 - Max Requests ........ 2
R - Return to Previous Menu
Enter your selection?