Allied Telesis AT-S60 - Manual (Page 72)

Chapter 3: Basic Switch Parameters
Section I: Basic Features 72
Returning the AT-S60 Software to the Factory Default Values
The procedure in this section returns all AT-S60 software parameters to
their default values. This procedure also deletes any VLANs that you
have created on the switch.
Note
The AT-S60 software default values can be found in Appendix A,
AT-S60 Default Settings on page 820.
To return the AT-S60 management software to its default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select the System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 - Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. Select D - Reset to Factory Defaults.
The following prompt is displayed:
Do you want to reset to Factory Defaults? [Yes/No] ->
5. Type Y for yes or N for no.
The following prompt is displayed:
Do you want to reset IP Configuration (Static/DHCP)
[Yes/No] ->
6. Choose from one of the following selections:
❑ Type Y (for yes) to configure all switch parameters with their
default values including the IP address, subnet mask, and gateway
address.
❑ Type N (for no) to configure all switch parameters with their
default values excluding the IP address, subnet mask, and
gateway address. (If you activated BOOTP and DHCP, resetting the
switch to its default settings disables BOOTP and DHCP.)
The following prompt is displayed:
Please reboot the switch for the Factory Defaults to
take effect.Switch is about to reboot. Do you want
to proceed? [Yes/No] ->