Allied Telesis AT-S60 - Manual (Page 547)

AT-S60 Management Software User’s Guide
Section V: Security Features 547
Configuring RADIUS
To configure RADIUS, perform the following procedure:
1. From the Main Menu, type 6 to select Security Menu.
The Security Menu is shown in Figure 151 on page 473.
2. From the Security Menu, select Server Based Authentication.
The Authentication Menu is shown in Figure 173 on page 544.
3. Type 4 to select RADIUS Configuration.
The RADIUS Client Configuration Menu is shown in Figure 175.
Figure 175 RADIUS Client Configuration Menu
4. Configure the parameters as needed. The parameters are defined
below:
Global Encryption Key
This parameter specifies the encryption key for the RADIUS
servers. This option is useful if you are entering more than one
RADIUS server and all the servers share the same encryption key.
If the servers use different encryption keys, leave this option
blank. Once you enter a key and press Return, the RADIUS Client
Configuration menu is updated with the key.
Global Server Timeout period
This parameter specifies the maximum amount of time the switch
waits for a response from a RADIUS server before assuming that
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:38 01-Jan-2004
RADIUS Client Configuration
1 - Global Encryption Key ............. ATI
2 - Global Server Timeout period....... 30 seconds
3 - RADIUS Server 1 Configuration ..... 0.0.0.0
4 - RADIUS Server 2 Configuration ..... 0.0.0.0
5 - RADIUS Server 3 Configuration ..... 0.0.0.0
6 - Show Status
R - Return to Previous Menu
Enter your selection?