Allied Telesis AT-S60 - Manual (Page 91)

AT-S60 Management Software User’s Guide
Section I: Basic Features 91
Deleting an
SNMPv1 and
SNMPv2
Community
To delete an SNMPv1 and SNMPv2c community, perform the following
procedure.
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure SNMP Menu is shown in Figure 22 on page 87.
5. To configure SNMPv1 and SNMPv2c parameters, type 3 to select
Configure SNMPv1 & SNMPv2c Community
The Configure SNMPv1 & SNMPv2c Community Menu is shown in
Figure 23 on page 89.
6. To remove an SNMPv1 and SNMPv2c community, type 2 to select
Delete SNMP Community.
The following prompt is displayed:
Enter SNMP Community Name:
7. Enter an SNMP community name from the list at the top of the menu.
The following prompt is displayed:
Do you want to delete this Community? (Y/N):
[Yes/No]->
8. Choose from the following options:
Y - Select Y to delete the SNMP community.
N -Select N to retain the SNMP community.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.