Allied Telesis AT-S60 - Manual (Page 391)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 391
Displaying SNMPv3 Table Menus
The procedures in this section describe how to display the SNMPv3
Tables. The following procedures are provided:
❑ Displaying the Display SNMPv3 User Table Menu on page 391
❑ Displaying the Display SNMPv3 View Table Menu on page 393
❑ Displaying the Display SNMPv3 Access Table Menu on page 394
❑ Displaying the Display SNMPv3 SecurityToGroup Table Menu on
page 395
❑ Displaying the Display SNMPv3 Notify Table Menu on page 396
❑ Displaying the Display SNMPv3 Target Address Table Menu on
page 397
❑ Displaying the Display SNMPv3 Target Parameters Table Menu on
page 398
❑ Displaying the Display SNMPv3 Community Table Menu on page
399
Displaying the
Display SNMPv3
User Table
Menu
This section describes how to display the Display SNMPv3 User Table
Menu. For information about the SNMPv3 User Table, see Creating an
SNMPv3 User Table Entry on page 305.
To display the Display SNMPv3 User Table Menu, perform the following
procedure.
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure SNMP Menu is shown in Figure 101 on page 306.
5. From the Configure SNMP Menu, type 6 to select Display SNMPv3
Table.