Allied Telesis AT-S60 - Manual (Page 388)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 388
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Security Name
To modify the Security Name parameter in an SNMPv3 Community Table
entry, perform the following procedure:
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is displayed as shown in
Figure 101 on page 306.
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table Menu is shown in
Figure 116 on page 383.
3. From the Configure SNMPv3 Community Table, type 3 to select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Community Table Menu is shown in Figure
117 on page 387.
4. To change the Security Name, type 2 to select Set Security Name.
The following prompt is displayed:
Enter Community Index:
5. Enter the Community Index of the Security Name you want to
change.
The following prompt is displayed:
Enter Security Name:
6. Enter the new Security Name.
Enter a value of up to 32-alphanumeric characters.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Transport Tag
To modify the Transport Tag parameter in an SNMPv3 Community Table
entry, perform the following procedure:
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.