Allied Telesis AT-S60 - Manual (Page 338)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 338
Modifying the Storage Type
To modify the Storage Type parameter in an SNMPv3 Access Table entry,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is shown in Figure 101 on
page 306.
2. From the Configure SNMPv3 Table Menu, type 4 to select Configure
SNMPv3 Access Table.
The Configure SNMPv3 Access Table is shown in Figure 106 on
page 325.
3. From the Configure SNMPv3 Access Table, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Table Menu is shown in Figure 107 on page
332.
4. To modify the Storage Type parameter, type 4 to select Set Storage
Type.
The following prompt is displayed:
Enter Group Name:
5. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model[1-v1, 2-v2c, 3-v3]:
6. Enter the Security Model configured for this Group Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value to associate the Group Name with the SNMPv1
protocol.
2-v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.
3-v3
Select this value to associate the Group Name with the SNMPv3
protocol.
The following prompt is displayed:
Enter Security Level [N-NoAuthNoPriv, A-AuthNoPriv,
P-AuthPriv]: