Allied Telesis AT-S60 - Manual (Page 305)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 305
Configuring the SNMPv3 User Table
This section contains a description of the SNMPv3 User Table and how to
create, delete, and modify table entries. Configure the SNMPv3 User
Table first. Creating this table, allows you to create an entry in an
SNMPv3 User Table for a User Name. In addition, this table allows you to
associate a User Name with the following parameters:
❑ Authentication Protocol
❑ Authentication Password
❑ Privacy Protocol
❑ Privacy Password
Note
You are prompted to configure the Privacy Protocol only if you are
using the encrypted version of the AT-S60 software.
There are three functions you can perform with the SNMPv3 User Table.
❑ Creating an SNMPv3 User Table Entry on page 305
❑ Deleting an SNMPv3 User Table Entry on page 309
❑ Modifying an SNMPv3 User Table Entry on page 310
Creating an
SNMPv3 User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure System Software Menu is shown in Figure 101 on
page 306.
5. From the Configure SNMP Menu, type 5 to select Configure SNMPv3
Table.