Allied Telesis AT-S60 - Manual (Page 248)

Chapter 15: STP and RSTP
Section II: Advanced Features 248
Configuring RSTP
This section contains the following procedures:
❑ Configuring RSTP Bridge Settings on page 248
❑ Configuring RSTP Port Parameters on page 252
❑ Displaying RSTP Port Configuration and Port State on page 254
Configuring
RSTP Bridge
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The default RSTP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how RSTP works might have a negative effect on your network.
Consult the IEEE 802.1w standard before you change any RSTP
parameters.
Note
You cannot configure RSTP settings unless the protocol has been
selected as the active spanning tree protocol on the switch. For
instructions, refer to Enabling or Disabling STP and RSTP on page
240.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 74 on page 240.
2. From the Spanning Tree Menu, type 4 to select RSTP Configuration.