Allied Telesis AT-S60 - Manual (Page 385)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 385
Note
The Row Status parameter is a read-only field in the Telnet and Local
interfaces. The Active value indicates the SNMPv3 Community Table
entry takes effect immediately.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3
Community
Table Entry
You may want to delete an entry from the SNMPv3 Community Table.
When you delete an entry in the SNMPv3 Community Table, there is no
way to undelete or recover it.
To delete an entry in the SNMPv3 Community Table, perform the
following procedure:
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is shown in Figure 102 on
page 307.
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table Menu is shown in
Figure 116 on page 383.
3. To delete an entry in the SNMPv3 Community Table, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Community Index:
4. Enter the Community Index that you want to delete.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):
[Yes/No]->
5. Choose one of the following:
Y
Type Y to delete an SNMPv3 Community table entry.
N
Type N to retain the SNMPv3 Community table entry.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.