Allied Telesis AT-S60 - Manual (Page 720)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 720
The SNMPv3 SecurityToGroup Table Page is shown in Figure 252
on page 717.
4. Click the circle next to the SecurityToGroup Table entry that you want
to delete. Then click Remove.
A warning message is displayed. Click OK to remove the SNMPv3
SecurityToGroup Table entry.
5. To save your changes, return to the General Tab and click Save
Changes.
Modifying a
SecurityToGroup
Table Entry
To modify an entry SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 252
on page 717.
4. Click the circle next to the SecurityToGroup Table entry that you want
to change. Then click Modify.
The Modify SNMPv3 SecurityToGroup Page is shown in Figure
254.
Figure 254 Modify SNMPv3 SecurityToGroup Page