Allied Telesis AT-S60 - Manual (Page 698)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 698
Configuring the SNMPv3 User Table
You can create, delete, and modify an SNMPv3 User Table entry. See the
following procedures:
❑ Creating a User Table Entry on page 698
❑ Deleting a User Table Entry on page 701
❑ Modifying a User Table Entry on page 702
For reference information about the SNMPv3 User Table, see
Configuring the SNMPv3 User Table on page 305.
Creating a User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
User Table. Then click Configure at the bottom of the page.