Allied Telesis AT-S60 - Manual (Page 814)

Chapter 46: 802.1x Port-based Network Access Control
Section VI: Web Browser Management 814
Configuring a
Supplicant Port
This section provides a procedure to configure the supplicant port
settings using a web browser management session. Before you can
configure supplicant settings, you need to set the role of the port on the
switch to supplicant. See Setting the Port Role on page 810.
To configure a supplicant port, perform the following procedure:
1. On the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
shown by default.
2. Select the Layer 1 option.
The Layer 1 Page is shown with the Port Settings Tab shown by
default.
3. Select the 802.1x Port Access Tab.
The Configuration 802.1x Port Access Tab is displayed as shown in
Figure 301 on page 808.
Note
You must set the port role as supplicant before you can configure a
supplicant port. See Setting the Port Role on page 810.
4. Click on a supplicant port or ports and click Settings.
The Supplicant Parameters Page is displayed, as shown in
Figure 304.
Figure 304 Supplicant Parameters Page