Allied Telesis AT-S60 - Manual (Page 314)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 314
Modifying the Storage Type
To modify the Storage Type in an SNMPv3 User Table entry, perform the
following procedure.
1. Follow steps 1 through 5 in the procedure described in Configuring
the SNMPv3 User Table on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 User Table Menu is shown in Figure 101
on page 306.
2. From the Configure SNMPv3 Table Menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 102 on page 307.
3. From the SNMPv3 User Table, type 3 to select Modify SNMPv3 Table
Entry.
The Modify SNMPv3 Table Menu is shown in Figure 103 on page
311.
4. To change the storage type, type 3 to select Set Storage Type.
The following prompt is displayed:
Enter User (Security) Name:
5. Enter the User Name.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 User Table to nonvolatile memory. After
making changes to an SNMPv3 User Table entry with a Volatile
storage type, the S - Save Configuration Changes option does not
appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 User Table to nonvolatile memory. After making
changes to an SNMPv3 User Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.