Allied Telesis AT-S60 - Manual (Page 429)

AT-S60 Management Software User’s Guide
Section IV: VLANs 429
c. If you want to remove one or more tagged ports from the VLAN,
enter the ports at this prompt. If you are not removing tagged
ports, press Return. For information on entering ports, refer to
Specifying Ports on page 34.
The following prompt is displayed:
Enter Untagged Port-list to delete:
d. If you want to remove one or more untagged ports from the
VLAN, enter them at this prompt. If you are not removing
untagged ports, press Return.
Changes are immediately activated on the VLAN.
Note
Untagged ports that are removed from a VLAN are automatically
returned to the Default_VLAN.
You cannot remove an untagged port directly from the
Default_VLAN. Instead, you must assign it as an untagged port to
another VLAN.
e. Repeat this step to modify other VLANs.
f. After modifying a VLAN, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.
3 - Set Ports to VLAN
To remove all ports from a VLAN while assigning new ports, do the
following:
a. Type 3 to select Set Ports to VLAN.
The following prompt is displayed:
Enter VLAN ID: [2 to 4094] ->
b. Enter the VID of the VLAN you want to change.
The following prompt is displayed:
Enter Tagged Port-list:
c. Enter the new tagged ports for the VLAN. To remove all tagged
ports without assigning new ports, press Return.
The following prompt is displayed:
Enter Untagged Port-list:
d. Enter the new untagged ports from the VLAN. To remove all
untagged ports without assigning new ports, press Return.
Changes are immediately activated on the VLAN.
e. After modifying a VLAN, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.