Allied Telesis AT-S60 - Manual (Page 453)

AT-S60 Management Software User’s Guide
Section IV: VLANs 453
Configuring GVRP
Use the following procedure to configure GVRP.
The timers in the following menus are in increments of centi seconds
which is a hundredth of a second.
To configure GVRP, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
The VLAN Menu is shown in Figure 130 on page 418.
2. From the VLAN Menu, type 3 to select Configure GARP-GVRP.
The GARP-GVRP Menu is shown in Figure 140.
Figure 140 GARP-GVRP Menu
3. Type 1 - GVRP Status to enable or disable GVRP.
The following prompt is displayed:
Enter your new value (E-Enabled, D-Disabled):
4. Choose one of the following:
E to enable GVRP.
D to disable GVRP. This is the default setting.
5. Type 2 - GVRP GIP Status to enable or disable GIP.
Enter your new value (E-Enabled, D-Disabled):
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Production Switch 4
User: Manager 00:14:33 24-May-2004
GARP-GVRP Menu
1 - GVRP Status ........... Disabled
2 - GVRP GIP Status ....... Enabled
3 - GVRP Join Timer ....... 20
4 - GVRP Leave Timer ...... 60
5 - GVRP Leave All Timer .. 1000
P - GVRP Port Parameters
O - Other GVRP Parameters Menu
D - Reset GVRP to Defaults
U - Update Display
R - Return to Previous Menu
Enter your selection?