Allied Telesis AT-S60 - Manual (Page 386)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Protocol 386
Modifying an
SNMPv3
Community
Table Entry
For each entry in the SNMPv3 Community Table, you can modify the
following parameters:
❑ Community Name
❑ Security Name
❑ Transport Tag
❑ Storage Type
However, you cannot modify the Community Index parameter.
Although you can display the SNMPv1 and SNMPv2c configuration
created with the procedures described in Configuring the SNMPv1 and
SNMPv2c Protocols on page 86, you cannot modify these Community
Table entries with the SNMPv3 Tables.
See the following procedures:
❑ Modifying the Community Name on page 386
❑ Modifying the Security Name on page 388
❑ Modifying the Transport Tag on page 388
❑ Modifying the Storage Type on page 389
Modifying the Community Name
To modify the Community Name parameter in an SNMPv3 Community
Table entry, perform the following procedure:
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is displayed Figure 101 on
page 306.
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table Menu is shown in
Figure 116 on page 383.
3. From the Configure SNMPv3 Community Table, type 3 to select
Modify SNMPv3 Table Entry.