Associating vlans to msti ids – Allied Telesis AT-S60 User Manual
Page 283
AT-S60 Management Software User’s Guide
Section II: Advanced Features
283
Modifying an MSTI ID
To change the MSTI priority value for an MSTI, do the following:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 91 on page 275.
2. From the Spanning Tree Menu, type 5 to select MSTP Configuration.
The MSTP Menu is shown in Figure 92 on page 277.
3. From the MSTI Menu, type 3 to select MSTI Configuration Menu.
The following prompt is displayed:
Enter the MSTI ID to be modified: [1 to 15] ->
4. Enter the MSTP IDs that you want to modify.
The range is 1 to 15. You can specify only one MSTI ID at a time.
The following prompt is displayed:
Enter new priority [the value will be multiplied by
4096] [0 to 15] -> 8
5. Enter a new MSTI priority number for this MSTI on the bridge.
This parameter is used in selecting a regional root for the MSTI.
The range is 0 (zero) to 61,440 in increments of 4,096, with 0 being
the highest priority. This parameter is used in selecting a regional
root for the MSTI. For a list of the increments, refer to Table 9 on
page 231.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Associating
VLANs to MSTI
IDs
When you create a new MSTI ID, you are given the opportunity to
associating VLANs to it. But, once a MSTI ID is created, there might come
a time when you want to add more VLANs to it, or perhaps remove
VLANs.
This section provides the following procedures:
❑ Adding or Removing a VLAN from an MSTI ID on page 284
❑ Associating a VLAN to an MSTI ID on page 286
❑ Removing a VLAN from an MSTI ID on page 286
❑ Associating VLANs to an MSTI ID and Deleting All Associated