Allied Telesis AT-S60 - Manual (Page 601)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 601
Manager IP Address1 through Manager IP Address 8
Enter an IP Address of a switch that is permitted SNMP manager
access to the current switch. You can enter up to 8 Manager IP
Addresses.
Trap Receiver IP Address 1 through Trap Receiver IP Address 8
Use the above selections to specify the IP addresses of up to 8 trap
receivers on your network that can receive traps from the switch.
6. Click Apply to update the SNMPv1 and SNMPv2c Modify Web Page.
7. To save your changes, return to the General Tab and click Save
Changes.
Deleting an
SNMPv1 and
SNMPv2c
Community
To delete an existing SNMPv1 and SNMPv2c community, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. Select Configure in the SNMPv1 & SNMPv2c section of the SNMP Tab.
The SNMPv1 & SNMPv2c Communities Page is shown in Figure
196 on page 597.
4. To remove an SNMPv1 & SNMPv2c community, click the circle next to
the community name and click Remove.
A warning message is displayed. Click OK to remove the SNMP
community.
5. To save your changes, return to the General Tab and click Save
Changes.
Displaying the
SNMPv1 and
SNMPv2c
Communities
To display the SNMPv1 and SNMPv2c communities, perform the
following procedure:
1. From the Home Page, select Monitoring.
The Monitoring System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 592.
2. Select the SNMP Tab.