Allied Telesis AT-S60 - Manual (Page 284)

Chapter 16: Multiple Spanning Tree
Section II: Advanced Features 284
Adding or Removing a VLAN from an MSTI ID
This procedure explains how to associate VLANs on the switch to an
existing MSTI ID and also how to remove VLANs. Before performing this
procedure, note the following:
❑ You must create a MSTI ID before you can assign VLANs to it. To
create a MSTI ID, refer to Creating, Deleting, and Modifying MSTI
IDs on page 280.
❑ You can assign a VLAN to only one MSTI. By default, a VLAN, when
created, is associated with the CIST instance, which has a MSTI ID
of 0.
❑ An MSTI can contain any number of VLANs.
To add or remove a VLAN from an MSTI ID, do the following:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 91 on page 275.
2. From the Spanning Tree Menu, type 5 to select MSTP Configuration.
The MSTP Menu is shown in Figure 92 on page 277.
3. From the MSTP Menu, type V to select VLAN-MSTI Association Menu.