Allied Telesis AT-S60 - Manual (Page 243)

AT-S60 Management Software User’s Guide
Section II: Advanced Features 243
The STP Menu is shown in Figure 75.
Figure 75 STP Menu
3. Adjust the bridge STP settings as needed. The parameters are
described below.
1 - Bridge Priority
The priority number for the bridge. This number is used in
determining the root bridge for RSTP. The bridge with the lowest
priority number is selected as the root bridge. If two or more
bridges have the same priority value, the bridge with the
numerically lowest MAC address becomes the root bridge. When
a root bridge goes off-line, the bridge with the next priority
number automatically takes over as the root bridge. This
parameter can be from 0 (zero) to 61,440 in increments of 4096,
with 0 being the highest priority. For a list of the increments, refer
to Table 9 on page 231, Bridge Priority Value Increments on page
231.
2 - Bridge Hello Time
The time interval, in seconds, between generating and sending
configuration messages by the bridge. This parameter can be
from 1 to 10 seconds. The default is 2 seconds.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
High School Switch 142
User: Manager 00:14:33 15-Jan-2004
STP Menu
1 - Bridge Priority ..... 32768
2 - Bridge Hello Time ... 2
3 - Bridge Forwarding ... 15
4 - Bridge Max Age ...... 20
5 - Bridge Identifier ... 00:30:84:EE:31:01
6 - Root Bridge ......... 00:30:84:EE:31:01
7 - Root Priority ....... 32768
P - STP Port Parameters
R - Reset STP to Defaults
R - Return to Previous Menu
Enter your selection?: