Allied Telesis AT-S60 - Manual (Page 325)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 325
The Configure SNMPv3 Access Table Menu is shown in Figure 106.
Figure 106 Configure SNMPv3 Access Table Menu
3. To create a group in the SNMPv3 Access Table, type 1 to select Create
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Group Name:
4. Enter a descriptive name of the group. The Group Name can consist
of up to 32-alphanumeric characters.
You are not required to enter a unique value here because the
SNMPv3 Access Table entry is indexed with the Group Name,
Security Model, and Security Level parameter values. However,
unique group names makes it easier to tell the groups apart.
There are four default values for this field:
❑ defaultV1GroupReadOnly
❑ defaultV1GroupReadWrite
❑ defaultV2cGroupReadOnly
❑ defaultV2cGroupReadWrite
These values are reserved for SNMPv1 and SNMPv2c
implementations.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
Configure SNMPv3 Access Table
Group Name .... softwareengineering Security Model . v3
Context Prefix. Security Level . AuthPriv
Read View...... internet Context Match .. Exact
Write View .... tcp Storage Type ... NonVolatile
Notify View ... tcp Row Status ..... Active
1 - Create SNMPv3 Table Entry
2 - Delete SNMPv3 Table Entry
3 - Modify SNMPv3 Table Entry
U - Update Display
R - Return to Previous Menu
Enter your selection?