Allied Telesis AT-S60 - Manual (Page 425)

AT-S60 Management Software User’s Guide
Section IV: VLANs 425
Example of Creating a Port-Based VLAN
The following procedure creates the Sales VLAN illustrated in Port-Based
Examples on page 408. This VLAN is assigned a VID of 2. It consists of
seven untagged ports, Ports 1 to 4 and 8 from the AT-8411 TX line card in
Slot 1 and Ports 1 and 2 from the AT-8411 TX line card in Slot 2. The VLAN
does not contain any tagged ports.
To create the example Sales VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
The VLAN Menu is shown in Figure 133 on page 421.
2. From the VLAN Menu, type 1 to select Configure VLAN.
The Configure VLAN menu is shown in Figure 133 on page 421.
3. From the Configure VLAN menu, type 4 to select Configure Port
Based VLAN.
The Configure VLAN Menu is shown in Figure 134 on page 422.
4. Type 1 to select Create Port Based VLAN.
The following prompt is displayed:
Enter VLAN Name:
5. Enter Sales. Press Return.
The following prompt is displayed:
Enter VID [2 to 4094]:
6. Enter 2. This is the VID value for the new VLAN. Press Return.
The following prompt is displayed:
Enter Tagged Port-list:
7. Because the Sales VLAN does not contain any tagged ports, you do
not enter any ports for this prompt. Press Return.
The following prompt is displayed:
Enter Untagged Port-list:
8. Enter “1.1-4,8,2.1-2”. These are the untagged ports of the Sales VLAN.
The management software automatically creates the new VLAN and
adds it to the list of VLANS in the menu.
9. Return to the Main Menu and type S to select Save Configuration
Changes.