Allied Telesis AT-S60 - Manual (Page 687)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 687
4. In the Priority field, enter a new MSTI Priority value. This parameter is
used in selecting a regional root for the MSTI. The range is 0 (zero) to
61,440 in increments of 4,096, with 0 being the highest priority. For a
list of the increments, refer to Table 9, Bridge Priority Value
Increments on page 231. The default is 0.
5. Click Apply.
To save your changes, return to the General Tab and click Save
Changes. The changes you made are saved on the switch.
6. Repeat this procedure to modify more MSTI IDs.
Adding,
Removing, or
Modifying VLAN
Associations to
MSTIs
This section explains how to add or remove VLANs associated to MSTI
IDs.
Adding a VLAN Association
To add a VLAN association, do the following:
1. Display the Spanning Tree Expanded Page for MSTP by performing
Steps 1 through 4 in the procedure Configuring MSTP Parameters on
page 681.
2. In the CIST/MSTI Table section of the tab, the VLAN Associations field,
enter the VIDs of the VLANS to be associated with this MSTI. You can
specify more than one VID at a time (for example, 2,4,7).
3. Click Apply.
To save your changes, return to the General Tab and click Save
Changes. The changes you made are saved on the switch. Or,
proceed to the next procedure to configure the CIST priority.
Removing a VLAN Association
To remove a VLAN association, do the following:
1. Display the Spanning Tree Expanded Page for MSTP by performing
Steps 1 through 4 in the procedure Configuring MSTP Parameters on
page 681.
2. In the CIST/MSTI Table section of the tab, the VLAN Associations field,
remove the VIDs of the VLANS that you no longer want to be
associated with this MSTI. You can specify more than one VID at a time
(for example, 2,4,7).
3. Click Apply.
To save your changes, return to the General Tab and click Save
Changes. The changes you made are saved on the switch. Or,
proceed to the next procedure to configure the CIST priority.