Allied Telesis AT-S60 - Manual (Page 479)

AT-S60 Management Software User’s Guide
Section V: Security Features 479
Configuring the Web Server for Security Features
This procedure allows you to enable, disable, and configure the web
server feature using a local or Telnet management session. In addition,
you can enable the SSL protocol on the web server using this procedure.
The default configuration for the switch is as a non-secure web server.
Note
Before you can configure the web server, you must disable it. Then
configure the web server settings and, finally, enable the web
server.
To configure the web server, perform the following procedure:
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software menu, type 5 to select
Configure Web Server.
The Web Server Configuration Menu is shown in Figure 155.
Figure 155 Web Server Configuration Menu
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
Web Server Configuration
1 - Status ................................. Enabled
2 - Mode ................................... HTTP
3 - Port Number ............................ 80
4 - SSL Key ID
R - Return to Previous Menu
Enter your selection?