Allied Telesis AT-S60 - Manual (Page 442)

Chapter 19: Multiple VLAN Modes
Section IV: VLANs 442
Changing the Uplink Port
Once the switch is operating in a Multiple VLAN mode, you can always
change the uplink port, if needed. You simply specify the new uplink
port and the switch automatically reconfigures the VLANs.
To change the uplink port, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
The VLAN Menu is displayed as shown Figure 133 on page 421.
2. From the VLAN Menu, type 1 to select Configure VLAN.
The Configure VLAN Menu is displayed as shown in Figure 133 on
page 421.
3. From the Configure VLAN menu, type 3 to select Set Uplink Port.
The following prompt is displayed:
Enter uplink port-list:
4. Enter the number of the port on the switch that is to function as the
new uplink port. You can specify only one port.
The following confirmation is displayed:
Setting VLAN mode to Multiple VLAN. Please wait...
The uplink port is changed.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.