Allied Telesis AT-S60 - Manual (Page 455)

AT-S60 Management Software User’s Guide
Section IV: VLANs 455
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
Allied Telesyn recommends disabling GVRP on unused ports and
those ports that are connected to GVRP-inactive devices. This is to
protect against unauthorized access to restricted areas of your
network. For further information, refer to GVRP and Network
Security on page 448.
1. From the Main Menu, type 2 to select VLAN Menu.
The VLAN Menu is shown in Figure 130 on page 418.
2. From the VLAN Menu, type 3 to select Configure GARP-GVRP.
The GARP-GVRP menu is shown in Figure 140 on page 453.
3. Type P - GVRP Port Parameters to configure the switch ports.
The GVRP Port Parameters Menu is shown in Figure 141.
Figure 141 GVRP Port Parameters Menu
4. Type 1 to configure GVRP Port Settings.
The following prompt is displayed:
Enter port-list:
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Production Switch 4
User: Manager 00:14:33 24-May-2004
GVRP Port Parameters
1 - Configure GVRP Port Settings
2 - Display GVRP Port Configuration
R - Return to Previous Menu
Enter your selection?