Allied Telesis AT-S60 - Manual (Page 94)

Chapter 5: SNMPv1 and SNMPv2c Configuration
Section I: Basic Features 94
11. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting Attributes from a Community
To delete an IP address from either the list of Manager IP addresses or
the list of Trap Receiver IP addresses, perform the following procedure:
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure SNMP Menu is shown in Figure 22 on page 87.
5. To configure SNMP parameters, type 3 to select Configure SNMPv1 &
SNMPv2c Community.
The Configure SNMPv1 & SNMPv2c Community Menu is shown in
Figure 23 on page 89.
6. To modify SNMP Community attributes, type 3 to select Modify SNMP
Community.
The Modify SNMPv1 and SNMPv2c Community menu is shown in
Figure 24 on page 93.
7. To delete an IP address from either the list of SNMP managers or the
list of trap receivers, type 2 to select Delete Attributes from
Community.
The following prompt is displayed:
Enter SNMP Community Name:
8. Enter a community name from the list at the top of the Modify
SNMPv1 & SNMPv2c Community Menu.
SNMP community names are case sensitive.
The following prompt is displayed:
Enter SNMP Manager IP Addr: