Allied Telesis AT-S60 - Manual (Page 275)

AT-S60 Management Software User’s Guide
Section II: Advanced Features 275
The Spanning Tree Menu is shown in Figure 91.
Figure 91 Spanning Tree Menu
Note
If you do not want to change the active spanning tree protocol and
just want to enable or disable it, go to step 6.
2. To change the active version of spanning tree protocol on the switch,
type 2 to select Active Protocol Version.
The following prompt is displayed:
This operation will need a reboot of the system.
Do you want to continue [Y/N] ->
3. Type Y for yes.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP, M-MSTP):
4. Type S to select STP, R to select RSTP, or M to select MSTP.
The following prompt is displayed:
Do you want to enable spanning tree? (Y/N) ->
If you select Yes to enable spanning tree, the management
software reboots the switch and enables the selected spanning
tree protocol. Enable spanning tree if you want to activate
spanning tree before you configure the MSTP parameter settings.
If you select No to disable spanning tree, the management
software reboots, but does not activate spanning tree. This
response is appropriate if you want to configure spanning tree
parameters before activating spanning tree.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
Spanning Tree Menu
1 - Spanning Tree Status ...... Disabled
2 - Active Protocol Version ... RSTP
3 - STP Configuration
4 - RSTP Configuration
5 - MSTP Configuration
R - Return to Previous Menu
Enter your selection?