Allied Telesis AT-S60 User Manual
Page 95
AT-S60 Management Software User’s Guide
Section I: Basic Features
95
9. Enter an IP address that you want to delete. Or, to skip this prompt,
press Return.
Delete an IP address to deny an SNMP manager to access the
switch. Use the following format for an IP address:
XXX.XXX.XXX.XXX
The following prompt is displayed.
Do you want to delete this SNMP Manager? (Y/N):
[Yes/No]->
10. Choose from the following options:
Y - Select Y to delete the IP address of this SNMP manager.
N - Select N to retain the IP address of the SNMP manager.
The following prompt is displayed:
Enter the Trap Receiver IP address:
11. Enter the Trap Receiver IP address that you want to delete. Or, to skip
this prompt, press Return.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
The following prompt is displayed:
Do you want to delete this Trap Receiver? (Y/N):
[Yes/No]->
12. Choose from the following options:
Y - Select Y to delete the IP address of the Trap Receiver.
N - Select N to retain the IP address of the Trap Receiver.
13. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Changing the Access Mode of a Community
Use this procedure to change the access mode of an SNMPv1 and
SNMPv2c community.
To enable or disable an SNMPv1 and SNMPv2c community, perform the
following procedure:
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.