Allied Telesis AT-S60 - Manual (Page 744)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 744
3. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 264 on
page 741.
4. Click the circle next to the SNMPv3 Community Table entry that you
want to change. Then click Modify.
The Modify SNMPv3 Community Table Page is shown in Figure
266.
Figure 266 Modify SNMPv3 Community Table Page
5. In the Community Name field, enter a Community Name of up to 64-
alphanumeric characters.
The value of the Community Name parameter acts as a password
for the SNMPv3 Community Table entry. This parameter is case
sensitive.
Note
Allied Telesyn recommends that you select SNMP Community
Names carefully to ensure these names are known only to
authorized personnel.
6. In the Security Name field, enter a name of an SNMPv1 and SNMPv2c
user.
This name must be unique. Enter a value of up to 32 alphanumeric
characters.