Allied Telesis AT-S60 - Manual (Page 365)

AT-S60 Management Software User’s Guide
Section III: SNMPv3 Protocol 365
Modifying the Target Parameters Field
To modify the Target Parameters field in an SNMPv3 Target Address
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in Creating an
SNMPv3 User Table Entry on page 305. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table Menu is shown in Figure 101 on
page 306.
2. From the Configure SNMPv3 Table Menu, type 7 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table Menu is shown in
Figure 112 on page 356.
3. From the Configure SNMPv3 Target Address Table Menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table Menu is shown in
Figure 113 on page 360.
4. To modify the Target Parameters field, type 6 to select Set Target
Parameters.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32-
alphanumeric characters.
The following prompt is displayed:
Enter Target Parameters:
6. Enter a Target Parameters Name.
The value configured here must match the value configured with
the Target Parameters Name parameter in the Configure SNMPv3
Target Parameters Table. This name can consist of up to 32-
alphanumeric characters.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.