Enable – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 97
Brocade 6910 Ethernet Access Switch Configuration Guide
41
53-1002651-02
4
General Commands
Command Usage
•
This command resets the entire system.
•
Any combination of reload options may be specified. If the same option is re-specified, the
previous setting will be overwritten.
•
When the system is restarted, it will always run the Power-On Self-Test. It will also retain all
configuration information stored in non-volatile memory by the
running-config
startup-config
command (See
Example
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2007 ---
***
Are you sure to reboot the system at the specified time?
enable
This command activates Privileged Exec mode. In privileged mode, additional commands are
available, and certain commands display additional information. See
Syntax
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec, 15: Privileged Exec. Enter
level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
•
“super” is the default password required to change the command mode from Normal Exec to
Privileged Exec. (To set this password, see the
command.)
•
The “#” character is appended to the end of the prompt to indicate that the system is in
privileged access mode.
Example
Console>enable
Password: [privileged level password]
Console#
Related Commands