Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 748)

692 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
33
Setting the System Clock
• Recurring – Sets the start, end, and offset times of summer time on a recurring basis.
• Offset – Summer time offset from the regular time zone. (Range: 0-99 minutes;
Default: 60 minutes)
• From – The recurring date and time at which to start using Summer Time settings.
• To – The recurring date and time at which to stop using Summer Time settings.
Interface
To configure Summer Time:
1. Click System, then Time.
2. Select Configure Summer Time from the Step list.
3. Set the Status to enable or disable Summer Time.
4. Fill in the Name field.
5. Then set the date and offset when using the Date or Recurring mode, or select one of the
geographic regions when using the Predefined mode.
6. Click Apply
FIGURE 23 Summer Time Settings