Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 696)

640 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
31
Debug Commands
link disconnect (25_6.0:7)(ROC) = 0xff
Console#
Console#debug hardware dev-swdrv port-map
unit=1 port= 1 => device_id= 0 module= 0 phy_port= 1 phy_id= 1
unit=1 port= 2 => device_id= 0 module= 0 phy_port= 0 phy_id= 0
unit=1 port= 3 => device_id= 0 module= 0 phy_port= 3 phy_id= 3
unit=1 port= 4 => device_id= 0 module= 0 phy_port= 2 phy_id= 2
unit=1 port= 5 => device_id= 0 module= 0 phy_port= 5 phy_id= 5
unit=1 port= 6 => device_id= 0 module= 0 phy_port= 4 phy_id= 4
unit=1 port= 7 => device_id= 0 module= 0 phy_port= 7 phy_id= 7
unit=1 port= 8 => device_id= 0 module= 0 phy_port= 6 phy_id= 6
unit=1 port= 9 => device_id= 0 module= 0 phy_port= 9 phy_id= 9
unit=1 port=10 => device_id= 0 module= 0 phy_port= 8 phy_id= 8
unit=1 port=11 => device_id= 0 module= 0 phy_port= 11 phy_id= 11
unit=1 port=12 => device_id= 0 module= 0 phy_port= 10 phy_id= 10
Console#
Console#debug hardware dev-swdrv stg
*** Dump STG ***
STG -- 0
VID : 1-4, 11-4093
BLK(P) : 2-12,
FWD(P) : 1,
STG -- 1
VID : 8,
BLK(P) : 1-12,
STG -- 2
VID : 7,
BLK(P) : 1-12,
STG -- 3
VID : 9,
BLK(P) : 1-12,
STG -- 4
VID : 6,
BLK(P) : 1-12,
...............................
debug ipcfg
This command shows detailed IP configuration settings for all IPv4 and IPv6 routing interfaces.
Syntax
debug ipcfg
Command Mode
Privileged Exec