Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 103)

Brocade 6910 Ethernet Access Switch Configuration Guide 47
53-1002651-02
Chapter
5
System Management Commands
In this chapter
The system management commands are used to control system logs, passwords, user names,
management options, and display or configure a variety of other system information.
Device Designation
This section describes commands used to configure information that uniquely identifies the switch.
TABLE 10 System Management Commands
Command Group Function
Device Designation Configures information that uniquely identifies this switch
Banner Information Configures administrative contact, device identification and location
System Status Displays system configuration, active managers, and version information
Frame Size Enables support for jumbo frames
File Management Manages code image or switch configuration files
Line Sets communication parameters for the serial port, including baud rate and
console time-out
Event Logging Controls logging of error messages
SMTP Alerts Configures SMTP email alerts
Time (System Clock) Sets the system clock automatically via NTP/SNTP server or manually
Time Range Sets a time range for use by other functions, such as Access Control Lists
TABLE 11 Device Designation Commands
Command Function Mode
hostname Specifies the host name for the switch GC
snmp-server contact Sets the system contact string GC
snmp-server location Sets the system location string GC