Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 569)

Brocade 6910 Ethernet Access Switch Configuration Guide 513
53-1002651-02
24
LLDP Commands
show lldp info remote-device
This command shows LLDP global and interface-specific configuration settings for remote devices
attached to an LLDP-enabled port.
Syntax
show lldp info remote-device [detail interface]
detail - Shows configuration summary.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show lldp info remote-device
LLDP Remote Devices Information
Interface Chassis ID Port ID System Name
--------- ----------------- ----------------- ---------------------
Eth 1/1 00-E0-0C-00-00-FD 00-E0-0C-00-01-02
Console#show lldp info remote-device detail ethernet 1/1
---------------------------------------------------------------
Local Port Name : Eth 1/1
Chassis Type : MAC Address
Chassis ID : 00-01-02-03-04-05
Port ID Type : MAC Address
Port ID : 00-01-02-03-04-06
System Name :
System Description :
Port Description : Ethernet Port on unit 1, port 1
SystemCapSupported : Bridge
SystemCapEnabled : Bridge
Remote Management Address :
192.168.1.2 (IPv4)
Remote Port VID : 1
Remote Port-Protocol VLAN :
VLAN-3 : supported, enabled
Remote VLAN Name :
VLAN-1 : DefaultVlan
Remote Protocol Identity (Hex) :
88-CC
Remote MAC/PHY Configuration Status :
Remote port auto-neg supported : Yes
Remote port auto-neg enabled : Yes
Remote port auto-neg advertised cap (Hex) : 0000
Remote port MAU type : 6