Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1187)

Brocade 6910 Ethernet Access Switch Configuration Guide 1131
53-1002651-02
47
Multicast VLAN Registration for IPv6
Parameters
These parameters are displayed:
Configure Profile
• Profile Name – The name of a profile containing one or more MVR6 group addresses.
(Range: 1-21 characters)
• Start IPv6 Address – Starting IP address for an MVR6 multicast group. This parameter must be
a full IPv6 address including the network prefix and host address bits.
• End IPv6 Address – Ending IP address for an MVR6 multicast group. This parameter must be a
full IPv6 address including the network prefix and host address bits.
Associate Profile
• Domain ID – An independent multicast domain. (Range: 1-5)
• Profile Name – The name of a profile to be assigned to this domain. (Range: 1-20 characters)
Interface
To configure an MVR6 group address profile:
1. Click Multicast, MVR6.
2. Select Configure Profile from the Step list.
3. Select Add from the Action list.
4. Enter the name of a group profile to be assigned to one or more domains, and specify a
multicast group that will stream traffic to participating hosts.
5. Click Apply.
FIGURE 405 Configuring an MVR6 Group Address Profile
To show the configured MVR6 group address profiles:
1. Click Multicast, MVR6.
2. Select Configure Profile from the Step list.
3. Select Show from the Action list.