beautypg.com

Ipv6 access-group, Show ipv6 access-group, Ipv6 access-group show ipv6 access-group – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 300

background image

244

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

11

IPv6 ACLs

Related Commands

“permit, deny (Standard IPv6 ACL)”

on page 241

“permit, deny (Extended IPv6 ACL)”

on page 242

“ipv6 access-group”

on page 244

ipv6 access-group

This command binds a port to an IPv6 ACL. Use the no form to remove the port.

Syntax

ipv6 access-group acl-name {in | out} [time-range time-range-name] [counter]

no ipv6 access-group acl-name {in | out}

acl-name – Name of the ACL. (Maximum length: 16 characters)

in – Indicates that this list applies to ingress packets.

out – Indicates that this list applies to egress packets.

time-range-name - Name of the time range.
(Range: 1-30 characters)

counter – Enables counter for ACL statistics.

Default Setting
None

Command Mode
Interface Configuration (Ethernet)

Command Usage
If a port is already bound to an ACL and you bind it to a different ACL, the switch will replace the old
binding with the new one.

Example

Console(config)#interface ethernet 1/2

Console(config-if)#ipv6 access-group standard david in

Console(config-if)#

Related Commands

“show ipv6 access-list”

on page 243

“Time Range”

on page 101

show ipv6 access-group

This command shows the ports assigned to IPv6 ACLs.

Command Mode
Privileged Exec

Example

Console#show ipv6 access-group

Interface ethernet 1/2

IPv6 standard access-list david in