Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1140)

1084 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
46
Domain Name Service
Parameters
These parameters are displayed:
• Name Server IP Address – Specifies the IPv4 or IPv6 address of a domain name server to use
for name-to-address resolution. Up to six IP addresses can be added to the name server list.
Interface
To create a list name servers:
1. Click IP Service, DNS.
2. Select Add Name Server from the Action list.
3. Enter one name server at a time.
4. Click Apply.
FIGURE 361 Configuring a List of Name Servers for DNS
To show the list name servers:
1. Click IP Service, DNS.
2. Select Show Name Servers from the Action list.
FIGURE 362 Showing the List of Name Servers for DNS
Configuring Static DNS Host to Address Entries
Use the IP Service > DNS - Static Host Table (Add) page to manually configure static entries in the
DNS table that are used to map domain names to IP addresses.
CLI References
• “ip host” on page 582
• “show hosts” on page 586