Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 555)

Brocade 6910 Ethernet Access Switch Configuration Guide 499
53-1002651-02
Chapter
24
LLDP Commands
In this chapter
Link Layer Discovery Protocol (LLDP) is used to discover basic information about neighboring
devices on the local broadcast domain. LLDP is a Layer 2 protocol that uses periodic broadcasts to
advertise information about the sending device. Advertised information is represented in Type
Length Value (TLV) format according to the IEEE 802.1ab standard, and can include details such as
device identification, capabilities and configuration settings. LLDP also defines how to store and
maintain information gathered about the neighboring network nodes it discovers.
TABLE 123 LLDP Commands
Command Function Mode
lldp Enables LLDP globally on the switch GC
lldp holdtime-multiplier Configures the time-to-live (TTL) value sent in LLDP advertisements GC
lldp notification-interval Configures the allowed interval for sending SNMP notifications about
LLDP changes GC
lldp refresh-interval Configures the periodic transmit interval for LLDP advertisements GC
lldp reinit-delay Configures the delay before attempting to re-initialize after LLDP ports are
disabled or the link goes down GC
lldp tx-delay Configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables GC
lldp admin-status Enables LLDP transmit, receive, or transmit and receive mode on the
specified port IC
lldp basic-tlv
management-ip-address Configures an LLDP-enabled port to advertise the management address
for this device IC
lldp basic-tlv
port-description Configures an LLDP-enabled port to advertise its port description IC
lldp basic-tlv
system-capabilities Configures an LLDP-enabled port to advertise its system capabilities IC
lldp basic-tlv
system-description Configures an LLDP-enabled port to advertise the system description IC
lldp basic-tlv
system-name Configures an LLDP-enabled port to advertise its system name IC
lldp dot1-tlv proto-ident * Configures an LLDP-enabled port to advertise the supported protocols IC
lldp dot1-tlv proto-vid * Configures an LLDP-enabled port to advertise port-based protocol related
VLAN information IC
lldp dot1-tlv pvid * Configures an LLDP-enabled port to advertise its default VLAN ID IC
lldp dot1-tlv vlan-name * Configures an LLDP-enabled port to advertise its VLAN name IC
lldp dot3-tlv link-agg Configures an LLDP-enabled port to advertise its link aggregation
capabilities IC