Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 148)

92 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
SMTP Alerts
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must enter a separate
command to specify each recipient.
Example
Console(config)#logging sendmail destination-email [email protected]
Console(config)#
logging sendmail source-email
This command sets the email address used for the “From” field in alert messages. Use the no form
to restore the default value.
Syntax
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages. (Range: 1-41
characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You may use an symbolic email address that identifies the switch, or the address of an
administrator responsible for the switch.
Example
Console(config)#logging sendmail source-email [email protected]
Console(config)#
show logging sendmail
This command displays the settings for the SMTP event handler.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19
SMTP Minimum Severity Level: 7