Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 596)

540 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
25
CFM Commands
Command Mode
CFM Domain Configuration
Command Usage
A change to the hold time only applies to entries stored in the database after this command is
entered.
Example
This example sets the aging time for missing MEPs in the CCM database to 30 minutes.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep archive-hold-time 30
Console(config-ether-cfm)#
clear ethernet cfm maintenance-points remote
This command clears the contents of the continuity check database.
Syntax
clear ethernet cfm maintenance-points remote [domain domain-name | level level-id]
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
level-id – Maintenance level. (Range: 0-7)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Use this command without any keywords to clear all entries in the CCM database. Use the domain
keyword to clear the CCM database for a specific domain, or the level keyword to clear it for a
specific maintenance level.
Example
Console#clear ethernet cfm maintenance-points remote domain voip
Console#
clear ethernet cfm errors
This command clears continuity check errors logged for the specified maintenance domain or
maintenance level.
Syntax
clear ethernet cfm errors [domain domain-name | level level-id]
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
level-id – Maintenance level. (Range: 0-7)
Default Setting
None